3D Hero Red PETG Review I will be honest here and state that I have had some terrible experiences with PETG in the past.  After using PLA, I became spoiled by the ease of printing with it.  I skipped the ABS bus entirely and...

That’s a HUGE Duck! The Great Duck Project was created as joint effort between two groups, The Maker Faire Westport and the Westport Sunrise Rotary club.  Mark Mathias, founder of the Maker Faire Westport, decided to use...

Introduction Sometimes, PLA just isn’t enough.  Typically the next step from here is either PETG or ABS.  What if you need something just a bit stronger, flexible, and easy to print?  You’re probably looking at some...

Introduction There’s been a lot of different manufacturers that have been adding things to their filaments lately.  They can range from carbon fiber strands, ACTUAL diamonds, all sorts of metallic powders, and finally.....

Introduction If you haven’t yet, check out my article on the Velocity Painting technique.  To quickly summarize my previous work, this post processing technique varies the speeds of your model’s outer shell to give...

Introduction Today I am going to go over a 3D printing technique called Velocity Painting.  This is a fun way to add a little extra to your 3D prints.  Do not confuse this technique with lithophanes.  Velocity Painting is a...